11-09-2012 02:10 AM - edited 03-10-2019 07:45 PM
Dear All,
I have one ASA with version 8.2 and i want to know whether below fearure are bydefault enable or not as in running config its not showing.
feature:
fragment chain 1
floodguard {enable}
Solved! Go to Solution.
11-10-2012 05:53 AM
Dear fm network,
Please refer below link for your question:
http://www.cisco.com/en/US/docs/security/asa/asa82/configuration/guide/conns_protect.html
Thanks and Regards,
Ashish Shirkar
(Technical community manager-Network Infrastructure)
11-09-2012 11:32 PM
Dear All,
I have one ASA with version 8.2 and i want to know whether below fearure are bydefault enable or not as in running config its not showing.
feature:
fragment chain 1
floodguard {enable}
11-10-2012 05:53 AM
Dear fm network,
Please refer below link for your question:
http://www.cisco.com/en/US/docs/security/asa/asa82/configuration/guide/conns_protect.html
Thanks and Regards,
Ashish Shirkar
(Technical community manager-Network Infrastructure)
11-10-2012 06:02 AM
there are two ways to find that out:
1) in the command-reference, all commands are shown with the defaults:
http://www.cisco.com/en/US/docs/security/asa/asa82/command/reference/cmd_ref.html
2) with the command
show runn all
you see all configuration including the defaults.
With that you see that the default fragment chain is 24 packets.
For floodguard it is not that easy to find out. There you have to know that it's a command from old PIX-times and is now enabled by default and not configurable.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: