cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
470
Views
0
Helpful
2
Replies

ASR - 1002 and Ip radius

Lance Wendel
Level 1
Level 1

hi all,

 

my customer trying to remove the aaa and tacacs server from the device and fails.

router#conf t
Enter configuration commands, one per line. End with CNTL/Z.
router(config)#no ip radius source-interface Loopback0 vrf DATA
router(config)#no ip radius source-interface Loopback0 vrf Mgmt
router(config)#do sh run | se radius
ip radius source-interface Loopback0 vrf BB2DATA
ip radius source-interface Loopback0 vrf Mgmt-intf
router(config)#no ip radiu
router(config)#no ip radius sou
router(config)#no ip radius source-interface loo
router(config)#no ip radius source-interface loo
router(config)#no ip radius source-interface loop
router(config)#no ip radius source-interface ?
<cr>
router(config)#no ip radius source-interface
router(config)#do sh run | se radius
ip radius source-interface Loopback0 vrf DATA
ip radius source-interface Loopback0 vrf Mgmt

 

we also tried removing the ip radius without the interface and still shows up with the above results.

rebooting is not an option as this is on a production environment.

currently he is on  Cisco IOS Software, IOS-XE Software (PPC_LINUX_IOSD-ADVIPSERVICESK9-M), Version 15.2(1)S, RELEASE SOFTWARE (fc1)and I could not find any bug/s on cisco tools.

with kind regards,

Lance

2 Replies 2

nkarthikeyan
Level 7
Level 7

Hi Lance,

 

Can you try like this as mentioned in the below command. This might solve your problem.

conf t# default ip radius source-interface Loopback0 vrf DATA

 

I made this attempt in a lab scenario it worked out.

 

R1(config)#do sh runn | in blue
ip vrf blue
ip radius source-interface Loopback0 vrf blue
R1(config)#def
R1(config)#defa
R1(config)#default ip radius source-interface loopback 0 vrf blue
R1(config)#do sh runn | in blue
ip vrf blue
R1(config)#ip vrf

Hope this helps

 

Regards

Karthik

Hi Karthik,

 

unfortunately it didnt worked, I have escalated the issue to TAC. the only thing I haven't done was to reload the device. its been up for over 2years and reload is not an option :(

regards,
lance

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: