cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
314
Views
0
Helpful
4
Replies
Highlighted
Beginner

can't configure tacacs-server port

We're unable to configure a specific port, which is required for our customer for the tacacs-server.   One of the devices is a 7604 router running this image -

c7600rsp72043-adventerprisek9-mz.122-33.SRD6.bin.  The other device is a 2960 switch with the following image - c2960-lanbasek9-mz.122-35.SE5.bin.

We don't get the option to add a port after the tacacs-server host x.x.x.x command. 

Any ideas would be greatly appreciated!

Regards..

4 REPLIES 4
Contributor

can't configure tacacs-server port

Hi

Please go through this link, this will be helpful regarding TCSACS Authentication and Fortigate configuration:

http://www.cisco.com/en/US/docs/net_mgmt/cisco_secure_access_control_system/5.2/user/guide/acsuserguide.html

Cisco Employee

can't configure tacacs-server port

Could you please paste the output of show run | in aaa from the router.

As far as I know to have more options with in the same command, you should have "aaa new-model" enabled on the IOS. For more info, please review the command reference of the same code.

~BR
Jatin Katyal

**Do rate helpful posts**

~Jatin Katyal
Cisco Employee

can't configure tacacs-server port

Did you get a chance to enable "aaa new-model". Just curious to know if it helps you to resolve the issue.

~BR
Jatin Katyal

**Do rate helpful posts**

~Jatin Katyal
Participant

can't configure tacacs-server port

Hello,

I think you might have forgotten to enable aaa with the command " aaa new model". After that it will work fine.

because we normally get the option to add the port.