11-23-2012 03:12 AM - edited 03-10-2019 07:49 PM
Hi,
I am trying to authenticate dot1x enabled wired endpoints through ISE. Initially after successful authentication , Authorization is set for to apply dAcl on Switch port. got expected result for same .
But when I try to apply Change of Vlan Auth profile(Instead of dAcl Authorization profile), did not get expected result.
1) ISE logs shows correct change of vlan authorization profile getting applied.
2) But when we checked on switch, it shows same old Vlan ,new profile is NOT ACTUALLy getting applied.
Any pointer how to troubleshoot.
11-23-2012 12:50 PM
Can you post screen shots form the details screen for the successful event? Also, post the output of the command "show authentication session interfaces x/y" after the authentication succeeds.
11-27-2012 04:34 AM
Hi Neno,
Thanks for reverting back. We have been using 2960 switch with IOS 12.2(52) SE (According to Trustsec 2.0 guideline). After upgrading it to 12.2(55) SE6 , Problem got resolved .
11-27-2012 09:05 AM
Very good! Glad you were able to find a solution! You should probably close the thread
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide