cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
320
Views
0
Helpful
3
Replies
Highlighted
Beginner

Cisco ISE rewrite

I would like to rewrite an identity mac address to parse out the - from xx-xx-xx-xx-xx-xx to a xxxxxxxxxxxx.  I am trying to use what an agency already built in AD to store MAC addresses instead of rebuilding and importing thousands of mac address.

3 REPLIES 3
VIP Advisor

Re: Cisco ISE rewrite

Hi

I just want to understand first what you're trying to achieve.
You want to rewrite the identity of mac address by removing dashes before sending it to AD for authentication?

Thanks
Francesco
PS: Please don't forget to rate and select as validated answer if this answered your question
Beginner

Re: Cisco ISE rewrite

I was able to find what I needed, I was trying to authenticate devices on to the network that are plugged into a Juniper switch.  The agency in question uses a windows radius server to authenticate the devices through mac address in AD.  I was trying to setup ISE to authenticate them using their AD.  After some tinkering and testing I was able to set up a policy set that would authenticate.  Their usernames at first were coming over with dashes and I needed them removed.  I reworked my protocols used and was able to fix my own issue.  Thanks though.

VIP Advisor

Re: Cisco ISE rewrite

Ok good you find a way to solve your issue.


Thanks
Francesco
PS: Please don't forget to rate and select as validated answer if this answered your question