cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
946
Views
3
Helpful
4
Replies

Cisco NAC: "Invalid switch configuration-OOB Error:OOB client "MAC/IP" not found."

Hi,

I am having the Cisco NAC enviroment (Software Version is 4.9.1) and OOB VG.

We are getting the below and attached Error while deploying on some machines.

"Invalid switch configuration-OOB Error:OOB client "mac/ip" not found."

Some users on same switches are working fine but some are not....

What would be the possibilities and any work around? other than keeping the port shudown for long time means that atleast 10 - 20 secs or more or a PC restart. Customer is not feeling comfortable with the current situation.

Any suggestions.....

Regards,

Mubasher

4 REPLIES 4

Cisco NAC: "Invalid switch configuration-OOB Error:OOB client "M

any update please...

Highlighted
Participant

Cisco NAC: "Invalid switch configuration-OOB Error:OOB client "M

Hello Mubashir,

Can you please add the following command to the Access Switches that the users are connecting to and experiencing the error?

"mac address-table notification mac-move"

Please update with the results after adding the command mentioned above.

Regards,

Carlos.

Advocate

Cisco NAC: "Invalid switch configuration-OOB Error:OOB client "M

In addition to what carlos said please check the snmp configuration...make sure the community strings match, the port has the snmp settings applied, and you can also check to see if you can read the port the manager GUI and also see if you can change the current vlan also.

Thanks,

Tarik Admani
*Please rate helpful posts*

Tarik Admani
*Please rate helpful posts*

Cisco NAC: "Invalid switch configuration-OOB Error:OOB client "M

Hi Carlos,

It seems fine after adding the suggested command. But, some of the switches are not supported like 2950. So, what we need to do in this case? and what is the purpose of this command exactly?

Please reply fast...

Regards,

Mubasher