cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
788
Views
0
Helpful
3
Replies

Cisco Prime LMS - Identity

I'm trying configure this feature and enable the identity capable devices option, but there is some CLI commands errors that were generated.

After job:
f1.bmp

Documentation:
fs1.bmp

How can i edit this (before job)? I would like delete these lines and i can't:
fs2.bmp

2 ACCEPTED SOLUTIONS

Accepted Solutions
Hall of Fame Cisco Employee

Cisco Prime LMS - Identity

You seem to have tickled what appears to be a device debug.  When you name your radius group, "radius" the CLI doesn't enter submode.  Change the radius group name to any other name, and this problem should go away.

Hall of Fame Cisco Employee

Re: Cisco Prime LMS - Identity

Perform another configuration sync under Configuration > Configuration Archive > Syncrhonization.

3 REPLIES 3
Hall of Fame Cisco Employee

Cisco Prime LMS - Identity

You seem to have tickled what appears to be a device debug.  When you name your radius group, "radius" the CLI doesn't enter submode.  Change the radius group name to any other name, and this problem should go away.

Re: Cisco Prime LMS - Identity

The work was executed successfully, but the switch still does not appear as an Identity Capable Devices, which the time for the Work Centers - Identity update the list? Can i change this delay or force to update?

Hall of Fame Cisco Employee

Re: Cisco Prime LMS - Identity

Perform another configuration sync under Configuration > Configuration Archive > Syncrhonization.