Framed-Ip-Address missing in Access-Request & Acct-Start messages

[rajkumaradass]

We have a Cisco 7206(IOS12.2(33)) equipment associated with freeRadius server2.1.10.  Upon PPPOE client start, dynamic IP is assigned from the IP-Pool to the PPPOE client. However this IP address, is not included in the Frame-IP-Address AVP sent in the Access-Request or Acct-Start message from the NAS. It is sent only in Acct-Update or Acct-Stop messages though,  I have enabled this AVP inclusion with the NAS command, radius-server attribute 8 include-in-access-req

Also i have attached the configuration used in NAS for your reference. Request to provide your inputs to get this resolved at the earliest.

Appreciate your inputs.

thanks,

Raj

[rajkumaradass]

It worked well, after adding "aaa accounting delay-start" to the conf file.

thanks,

Raj