Buy or Renew
Buy or Renew
Duo Security forums now LIVE! Get answers to all your Duo Security questions. Learn more
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
513
Views
0
Helpful
1
Replies

ISE - Inline Posture Node Deployment Issue - User can not access network after pass authentication checking

Tai Eric
Level 1
Level 1

‎07-08-2014 12:09 AM - edited ‎03-10-2019 09:51 PM

Hi Experts,

I have recently deployed a ISE iPEP in front of a Aruba WLC in bridge mode. After user pass authentication on Aruba WLC, I can see from Monitoring node that the employee role have been granted to the userand a "permit any any acl" has been pushed to IPN. However, user still can not have any network access. When I issue command :" show pep table accesslist normal" and " show pep table session" on IPN but it show nothing. Did anyone have experience the same issue? or any solution or recommended troubleshooting steps?

 

 

Regards,

Eric

 

Labels:
0 Helpful
1 Reply 1

Saurav Lodh
Level 7
Level 7

‎09-18-2014 08:45 AM

http://community.arubanetworks.com/t5/Controller-Based-WLANs/Does-Aruba-Controller-support-switching-vlan-using-COA/ta-p/194579

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents