cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
7357
Views
0
Helpful
4
Replies

ISE NTP Time Source

20190613_152122.png

 

I configured NTP point to my Window server for time synchronization.

Unfortunately ISE always select LOCAL(*127.127.1.0) as a time source.

Does we have any configuration to force the ISE to sync time with Window Server?

Thank for your kindly support.

Note that ISE is VM-based.

1 Accepted Solution

Accepted Solutions

ldanny
Cisco Employee
Cisco Employee

There is no way to force ISE to sync with NTP other then the command itself that should trigger a sync.

It just may be your looking at an issue with your Windows NTP setup.
You could quickly setup NTP on your switch and then point ISE to it , just to rule out issues.

View solution in original post

4 Replies 4

johnd2310
Level 8
Level 8

HI,

Have you looked at the following doc:

https://www.cisco.com/c/en/us/support/docs/security/identity-services-engine/119371-technote-ise-00.html

 

Thanks

John

**Please rate posts you find helpful**

ldanny
Cisco Employee
Cisco Employee

There is no way to force ISE to sync with NTP other then the command itself that should trigger a sync.

It just may be your looking at an issue with your Windows NTP setup.
You could quickly setup NTP on your switch and then point ISE to it , just to rule out issues.

Try to restart ntp service or delete the ntp server and readd as it takes
time to resync.

Mannyteck
Level 1
Level 1
How did you get this issue solved, I'm also using a VMware.. I had to disable the firewall on my server.
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: