cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1465
Views
0
Helpful
7
Replies

ise posture status notapplicable

ibrahim_hassan
Level 1
Level 1

Hello ,

         after upgrading ISE 1.2 to 1.2.1 , I can't see posture status (pending) although it is working properly. I tried to install patch 1 but the same result.

before upgrading , posture status was Pending when posture status still not reach to ISE.

7 Replies 7

ibrahim_hassan
Level 1
Level 1

Any help please , I think it may be a bug?
 

I have same problem too.

 

When workstation install NacAgent 4.9.4.3 successfully, then the posture will be stucked.

 

I didn't see about NAC Agent on report: "Posture Detailed Assessment" and "Client Provisioning"

 

Any help or advice please ? Should I configure the redirect ACL, dACL, switch ACL, or something like that ?

 

 

 

 

NAC Agent 4.9.4.3 takes a very long time to complete posture
CSCuq52821

Symptom:
NAC Agent 4.9.4.3 takes about an hour to complete posture

Conditions:
using NAC Agent 4.9.4.3

Workaround:
use NAC Agent 4.9.0.51

The posture is working fine , but i can't see the "Pending" status in posture status (attached).

it was working before (1.2 patch 5 ) upgrading to 1.2.1 patch1.

Saurav Lodh
Level 7
Level 7

This could be bug

I am facing the exact same issue with the latest 1.2.1 patch 2,

Does anybody have any confirmed Bug covering this issue ?

 

 

ibrahim_hassan
Level 1
Level 1

Thanks , Resolved in 1.3 :)

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: