09-16-2013 02:44 AM - edited 03-10-2019 08:54 PM
Hi forum,
I have a question. I 'm configuring parse view.
How to config to give only right to "shutdown", "no shutdown", and "switchport access vlan" in interface mode. All other commands are denied.
One more question. I create a username and assign to a view, however after entering this username/pass, it does not go dirrect into view mode. I have to enable continue "enable view xxx". It 's very incovenience.
Thanks for any advices.
09-23-2013 04:09 AM
commandsparser-mode {include | include-exclusive | exclude} [all] [interface interface-name | command]
parser-mode--The mode in which the specified command exists.
http://www.cisco.com/en/US/docs/ios/12_3t/12_3t7/feature/guide/gtclivws.html
09-23-2013 04:38 AM
Hi,
But to my case, I have to enter many commands "commands configure include interface GigabitEthernet0/1" ... to Gigabit0/48, in addition to your command "commands interface include no shutdown"
Are there any solutions to reduce the job of mine, and the config file long?
Thanks,
09-26-2013 02:13 AM
Hi Team.
""One more question. I create a username and assign to a view, however after entering this username/pass, it does not go dirrect into view mode. I have to enable continue "enable view xxx". It 's very incovenience""
I also have with the same this problem , after enter username/password.
It only go to exec mode (user), not go dirrect to exec mode (privileged), althought i was assign user to view name.
example : username operator view operator_mode secret operatorpswd
Please help me some advise.
Thank you.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: