02-20-2014 04:50 AM - edited 03-10-2019 09:25 PM
How to configure per user bandwidth rate limit for wireless guest client, authentication server is ISE 1.2 & wireless controller is 5760.
02-20-2014 09:03 AM
There are Advanced Attribute Settings in the Authorization profiles.
There is a bug in WLC code that effectively ignores the AV pairs sent from ISE.
Bug id is CSCsd14297. Should be fixed in 8.0 code.
Will have to wait for that version for now.
02-21-2014 01:53 AM
WLC code 7.3 onwards you can do bi-directional rate limiting chech the guide given below or use third party solution
02-21-2014 12:33 PM
The Cisco 5760 WLC supports better QoS than other c
ontrollers, allowing prioritization of mission-crit
ical
applications:
●
The Cisco 5760 WLC supports four wireless hardware
queues and priority-based queuing compared to
software-based queuing in existing controllers.
●
The Cisco 5760 WLC follows MQC based commands, allo
wing usage of exact commands for configuring
QoS on different types of network devices.
●
The Cisco 5760 WLC supports QoS policies to be appl
ied in a hierarchical fashion with more granularity
per SSID per radio, while on the current controller
s granularity is per WLAN.
●
The Cisco 5760 WLC supports approximate fair bandwi
dth to make sure of fairness at client, SSID, and
radio levels for Non-Real Time (NRT) traffic. There
fore, if one user consumes excessive bandwidth, we
can
limit the amount of bandwidth that user receives an
d thereby not deprive other users.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: