cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
382
Views
0
Helpful
1
Replies
Highlighted
Beginner

VG202XM as dot1x supplicant

Hello Community,

i have some troubles about my VG202XM as dot1x supplicant. I have found some informations to configure a normal router as a dot1x supplicant. But this commands are not work.

The tested way was:

en

conf t

dot1x credentials test

username test1

password test2

exit

interface fa 0/1

dot1x pae supplicant

Command rejected: Dot1x is not supported.

Dot1x is supported only on Ethernet interfaces configured in Access, Routed or Private-vlan Host Mode.

I can not type "switchport mode access" because it is a router not a layer 3 switch. I had add on this interface a ip address but there was the some message. I have no idea ....

ip routing <- is set

I hope anybody can help me.

1 REPLY 1
Beginner

Hi Markus, they were opened a

Hi Markus,

 

they were opened a TAC-Case with an Defect-id.

#CSCus38551

 

best regards 

Andi