04-23-2008 07:46 AM - edited 03-05-2019 10:33 PM
I have a 2801 router with advanced ip services installed on it (12.4-15T). After rebooting and getting ready to configure I noticed an NVRAM error message:
NV_BLOCK_INITFAIL: Unable to initialize the geometry of NVRAM
The recommended action is to reduce the configurations in the NVRAM
As I do not have any, I tried to copy over the running-config which appears to be fine, but it fails with the following:
startup-config file open failed (Unknown error 0).
Even trying to "show file info nvram" it is returning %Error opening flash:nvram (file not found).
Is this error fixable, do I need to open a TAC?
Solved! Go to Solution.