I installed an RV042 this weekend at my home office that has dual DSL connections. The unit works great except now I am offsite and I cannot get to the VPN. The frustrating thing is that the quickVPN CONNECTS it just does not verify the connection via the remote ping.
2009/06/08 08:48:19 [STATUS]OS Version: Windows XP
2009/06/08 08:48:19 [STATUS]Windows Firewall is OFF
2009/06/08 08:48:19 [STATUS]One network interface detected with IP address 10.15.25.xxx
2009/06/08 08:48:19 [STATUS]Connecting...
2009/06/08 08:48:26 [STATUS]Remote gateway was reached by https ...
2009/06/08 08:48:26 [STATUS]Provisioning...
2009/06/08 08:48:33 [STATUS]Tunnel is connected successfully.
2009/06/08 08:48:33 [STATUS]Verifying Network...
2009/06/08 08:48:37 [WARNING]Failed to ping the remote VPN Router!
2009/06/08 08:48:38 [WARNING]Failed to ping the remote VPN Router!
2009/06/08 08:48:39 [WARNING]Failed to ping the remote VPN Router!
2009/06/08 08:48:40 [WARNING]Failed to ping the remote VPN Router!
2009/06/08 08:48:41 [WARNING]Failed to ping the remote VPN Router!
2009/06/08 08:48:42 [WARNING]Ping was blocked, which can be caused by an unexpected disconnect.
As you can see the windows firewall is off, I have a 10.15.25 address on the client side, (The VPV side is 192.168.100.xxx). So the tunnel connects okay but the network verification fails. SO this means that 443 from where I am is open. Of course who would block 443 anyhow? Is there an access rule that needs to be created to allow ping to the local address of the router or something? If so that is not in the documentation anywhere. Help please?
