12-16-2009 01:25 AM - edited 03-04-2019 06:59 AM
Hi All,
My company has recently purchase Cisco VWIC-2MFT-G703 card for our new MPLS link setup & I have asked to configure it on Cisco 2811 series router. I can see that my router is detecting card I have installed it in slot number 2 of router but I am unable to configure it. I have tried several commands from Cisco on-line documentation but it didn't help me. Here is the output of those commands...
Cisco2811(config)#card type E1 2
Card in slot 2 was removed or does not support command.
Also this...
Cisco2811(config)#interface serial 0/2/0
^
% Invalid input detected at '^' marker.
Could you please suggest me if there is any other command to configure VWIC card on Cisco 2811? Or does it need any activation?Here is the show diag for slot 2 of router...
WIC Slot 2:
VWIC2-2MFT-G703 - 2-Port RJ-48 Multiflex Trunk - T1/E1 & G.703
Hardware Revision : 0.0
Top Assy. Part Number : 800-24920-05
Board Revision : C0
Deviation Number : 0
Fab Version : 04
PCB Serial Number : FOC13224KDS
RMA Test History : 00
RMA Number : 0-0-0-0
RMA History : 00
Product (FRU) Number : VWIC2-2MFT-G703
Version Identifier : V01
EEPROM format version 4
EEPROM contents (hex):
0x00: 04 FF 40 03 FB 41 00 00 C0 46 03 20 00 61 58 05
0x10: 42 43 30 88 00 00 00 00 02 04 C1 8B 46 4F 43 31
0x20: 33 32 32 34 4B 44 53 03 00 81 00 00 00 00 04 00
0x30: CB 8F 56 57 49 43 32 2D 32 4D 46 54 2D 47 37 30
0x40: 33 89 56 30 31 20 D9 02 40 C1 FF FF FF FF FF FF
0x50: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
0x60: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
0x70: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
Attached is the running config of router. Router IOS version is Version 12.4(13r)T
Thanks in advance.
Ganesh C. Palav