06-09-2010 07:42 AM - edited 02-21-2020 04:41 PM
We actually install AnyConnect 2.4.1012 on many clients with lots of different configurations.
So we have many different issues but one of the main problems is, that AnyConnect and McAfee don't work together.
I have tested the following and could reenact the issue (also with 2.5).
If the AnyConnect client is installed there's a new interface in network connections with an ordinary name (like 'LAN connection 4').
First time I establish a VPN connection the interface gets renamed to 'Cisco AnyConnect VPN Client Connection'.
The connection established until AnyConnect get's an IP address from the ASA.
After that, vpnupdater starts and connection crashes.
At that moment McAfee Internet Security blocks further traffic and there's no chance to get it running until McAfee is reinstalled.
AnyConnect reports: The VPN client driver has encountered an error.
In my opinion the main problem is the renaming
of the interface.
Does anyone have a solution?
How can I prevent AnyConnect to change the interface name?