Good morning every body :-)
i need your help;
i activated the port security in my packet tracer, and now this is what i have:
Switch#show port-security int fast 0/3
Port Security : Enabled
Port Status : Secure-up
Violation Mode : Shutdown
Aging Time : 0 mins
Aging Type : Absolute
SecureStatic Address Aging : Disabled
Maximum MAC Addresses : 1
Total MAC Addresses : 1
Configured MAC Addresses : 1
Sticky MAC Addresses : 0
Last Source Address:Vlan : 00D0.D3D1.3B86:1
Security Violation Count : 0
actually i have 2 problems
1-i want desable port security
2-Sticky mac addresses is working fine after configuration, but it show always 0 except if i change Maximum MAC Addresses; is-it normal, or i made a mistake.
thank you very much for your help.
i'm new in cisco switching so i appreciate so much your help :-)
Regards.
