WS-C3560.
(C3560-IPBASEK9-M), Version 12.2(44)SE2
I have this 3560 that has been causing problems, I have just removed the config and restarted from scratch.
I have set 2 vlans up with IP's.
All fine so far..
half the ports are in 1 vlan/ half in the other.
Still fine.
What I am unsure of is why some ports ( not even connected ) are showing trunk pruning.
================================
interface FastEthernet0/9
switchport access vlan 3
switchport mode access
!
interface FastEthernet0/10
switchport access vlan 3
switchport mode access
!
interface FastEthernet0/11
switchport access vlan 3
switchport trunk pruning vlan 2-1000
switchport mode access
================================
I can remove the command with "no switchort trunk pruning vlan"
but it may com back, or appear on another port.
So is this normal? or very odd?
Full file attatched.
Thanks
Rob
