10-04-2010 11:36 AM - edited 03-06-2019 01:18 PM
I have a setup that i need to capture traffic from 6 non cisco switches for a one port traffic analyzer.
(the solution of remote span and span vlan is not supported on these switches)
So my solution would be to get the traffic from the 6 switches on 6 ports on the 3560 switch.
So to prevent loops, i need to make the ports receiving the traffic from the non-cisco switched to be receive only ports.
To receive the tarffic on 6 ports ( receive only) and then span the traffic to the analyzer
Is a thing like this possible?
How I could configure a port so as not to forward any frames?
Best Regards
Mohamed Sadek