10-15-2010 03:54 PM
Hi all,
I want to monitor the rxload and input rate on interfaces but I can't find the correct OID can someone help me with this please.
Can someone also provideme a good document for this
GigabitEthernet4/8 is up, line protocol is up (connected)
Hardware is Gigabit Ethernet Port, address is 000d.657d.3387 (bia 000d.657d.3387)
Description: --- 2924_MAIN ---
MTU 1500 bytes, BW 100000 Kbit, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Half-duplex, 100Mb/s, link type is auto, media type is 10/100/1000-TX
input flow-control is off, output flow-control is off
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:47, output never, output hang never
Last clearing of "show interface" counters 20w1d
Input queue: 0/2000/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 5000 bits/sec, 4 packets/sec
5 minute output rate 153000 bits/sec, 26 packets/sec
143271178 packets input, 34567505950 bytes, 0 no buffer
Received 2731549 broadcasts (295416 multicast)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 input packets with dribble condition detected
253476590 packets output, 117220536494 bytes, 0 underruns
1341644 output errors, 542074 collisions, 0 interface resets
0 babbles, 259071 late collision, 0 deferred
0 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out