11-08-2010 06:25 PM - edited 03-04-2019 10:24 AM
So I found some time to open up the new 1941ISR's I am
supose to be testing for the field. I am having hellish DMVPN issues but I will post about that later.
I am confused, lost, or just missdirected on the PoE and PfR functions of the 1941 or 15.0.1M4 IOS
I have no PfR, OER, or PoE commands in my CLI
For example the OER or PfR issue:
Edge1941-201#
Edge1941-201#config t
Enter configuration commands, one per line. End with CNTL/Z.
Edge1941-201(config)#oer ?
% Unrecognized command
Edge1941-201(config)#pfr ?
% Unrecognized command
Edge1941-201(config)#o?
object-group
Edge1941-201(config)#p?
parameter-map parser password policy-manager
policy-map ppp printer priority-list
privilege process process-max-time prompt
Edge1941-201(config)#
As you can see above, no OER, or PFR commands are in the global config, where did they go? The docs say the new 15.0 IOS support EIGRP route
injection with PfR and DMVPN. but when you read to set it up it states a prereq is to have OER functioning on the router? Some help on how to get it
working with no syntacs would be helpfull...
Now the inline power issue:
Edge1941-201#sh po?
policy-manager policy-map
Edge1941-201#config t
Enter configuration commands, one per line. End with CNTL/Z.
Edge1941-201(config)#po?
policy-manager policy-map
Edge1941-201(config)#
as you can see I have no "Sh inline power" command, or any other inline PoE commands weather in the interface config or global? Its great I have the
PoE power supplies with no command line to turn the function on for my PoE ether card.
I am guessing I was not paying attention during the evolution that took place between 12.4 and 15.0 so any help pointing me in the right direction would
be great. if I get some help I might just even post my latest DMVPN issue, or lack of DMVPN I should say. This is more of a IPsec/crypto issue on the 1941,
but again for another time.
Sorry if I sound cranky, but I am. Leave it to Cisco to screw up my week....
Thanks,
Dave