02-03-2011 12:38 PM - edited 07-03-2021 07:46 PM
Is there a way to configure an SNMP string on a lightweight access point (LWAPP)? WCS is running version 7.0.164.3. The 4402 controller is running version 7.0.98.0. The LWAPP is using image version 7.0.98.0. I can access the LWAPP using SSH and get to the enable prompt. Below are the commands I'm using.
AP01>ena
Password:
AP01#conf t
Enter configuration commands, one per line. End with CNTL/Z.
AP01(config)#snmp-server community mycomm ro
AP01(config)#exi
AP01#wr
Building configuration...
[OK]
NVRAM Verification Failed
AP01#
If there is a way to add the SNMP community from the controller or WCS, please let me know.
Thanks,
Tim
Solved! Go to Solution.