02-27-2011 10:50 PM - edited 03-11-2019 12:57 PM
Hello friends,
I had configure active standby failove on both device i.e below and i seen that once its configure after sometime its take priority 1st to secondary firewall and primanry firewall become standby state.
Also i check on show version command its show me that its active/active .
How can i check that its configure properly.
On Primary
failover
failover lan unit primary
failover lan interface failover Management0/0
failover interface ip failover 192.168.3.1 255.255.255.252 standby 192.168.3.2
On secondary
failover
failover lan unit secondary
failover lan interface failover Management0/0
failover interface ip failover 192.168.3.1 255.255.255.252 standby 192.168.3.2
Solved! Go to Solution.