We have a vg204 configured as a sccp gateway with 1 sccp analog phone configured. The corresponding fxs port is connected to a Valcom paging system. When a buttset is directly connected to the Valcom device, we get a second dialtone as expected and can press 0 for all zones, or 1 through whatever to page specific zones. After inputting a zone number or 0 for all, you hear a tone and can begin the page.
When dialing the directory number on the sccp analog phone, the paging system device picks up but there's no dialtone...just the tone and a hot mike to all of the paging zones. It's as if CUCM is sending an extra 0 to hit all the zones.
None of my debugs have captured anything useful looking, and it's sccp...so not much in the way of configs. Any ideas?
thanks,
will
