09-19-2011 09:44 PM - edited 03-04-2019 01:39 PM
I have been using the Cisco7613 chassis with PA-MCX-8TE1 module for TDM LSL.
(IOS version is 12.2IXH1)
To prevent the detect that transient connection lost, I has configured to Carrier-Delay function at serial interface.
But it was no effect. because it cannot configure at controller E1 interface too.
So If connection lost has occured, controller E1 interface has become to "down" state immediately.
Are there way to configure the Carrier-Delay at Controller E1 Interface level?