cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Who Me Too'd this topic

Cisco UCS Blades and vSphere DPM

jim_nickel
Beginner
Beginner

I followed this guide:

https://supportforums.cisco.com/docs/DOC-8582

And it worked, but I have 2 problems.

1) The blade being put into Standby starts back up immediately - almost like a reboot -

and doesn't stay in Standby mode

2) The Blade being put into Standby mode has Faults on all vFabric's etc because it is

"off"

Any suggestions?

Jim

Who Me Too'd this topic