I have a RV120W; configured to perform port forwarding. I have Configured a Port Forwarding and Access Rule
* Sample Firewall: Access Rules:
Action | Service | Status | Connection Type | Source IP | Destination IP
Always Allow | HTTP | Enabled | Inbound (WAN (Internet) > LAN (Local Network)) | Any | <not set>
Always Allow | SSH | Enabled | Inbound (WAN (Internet) > LAN (Local Network)) | Any | <not set>
* Sample Firewall:Port Forwarding:
Action | Service | Status | Source IP | Destination IP | Forward from Port | Forward to Port
Always Allow | HTTP | Enabled | Any | <destination ip> | <not set> | <not set>
Always Allow | SSH | Enabled | Any | <destination ip> | <not set> | <not set>
Everything works, but in my destination server, i see as remote address the IP for the RV120W. I want it to forward also the
originating IP address of the client (the remote address)
Is it possible to configure this?
I have also configured DMZ for my server, but see same behaviour
Firmware: 1.0.3.10
regards,
--
Bruno Antunes
