09-12-2012 11:33 PM - edited 03-04-2019 05:33 PM
Hi guys,
We have one cisco core switch 6500 series which was configured portchannel on several gig interfaces. This port is used as a trunk to enable communication between VLANs. The VLANs is where several high-end servers/hosts reside.
After we disable / unbind the portchannel, the port turns amber. The following is what we did on the interface
1- #no switchport command
2- make the port as access mode
#switchport mode access
3- shut and no shut
4- clear arp
5- clear mac
....
what else can we do on that particular interface. It is just on that particular interface, the rest are ok.
thanks