I've currently tried firmwares 1.0.3.5 and 1.0.4.17 and neither of the two work properly with split dns
1.0.1.0 doesn't support Split DNS .
Split DNS was implemented in 1.0.2.4 which was pulled, so I can't even test that.
You can find the release notes here:
http://www.cisco.com/en/US/docs/routers/csbr/rv220w/release/notes/RV220W_Release_Notes_1.0.2.4.pdf
But the download itself doesn't exist. I've combed the internet and nothing.
I've set up Split DNS before with two RV042s and it works fine.
So this is my setup:
Home:
RV220W
LAN: 192.168.1.x
Router: 192.168.1.1
Subnet: 255.255.255.0
Office:
RV042
LAN: 10.0.0.x
Router: 10.0.0.254
Subnet: 255.255.255.0 (this is intential)
Site to Site VPN:
Using RV220W's default IKE settings.
Split DNS Enabled
Primary DNS Server: 10.0.0.1
Primary Domain: dataprocomputers.com
(this is set up on the home network)
I'll skip the unnecessary stuff.
VPN connects fine. IKE is all good. Everything pings.
nslookup pdc01.dataprocomputers.com. 10.0.0.1
response is good
nslookup pdc01.dataprocomputers.com. 192.168.1.1
no response
DNS Proxy enabled and disabled makes no difference.
Changing the RV220W's DHCP domain name to dataprocomputers.com doesn't matter
With Split DNS disabled 192.168.1.1 will respond with the WAN IP (because it's using the ISP). That's expected
With Split DNS enabled 192.168.1.1 never responds (no ip given)
Has anybody ever got Split DNS to work on 1.0.3.5 and higher? Can somebody share their 1.0.2.4 to see if this issue is on 1.0.3.5 and above?
