01-26-2013 08:31 PM - edited 02-21-2020 06:39 PM
Hi;
my employer is switching from Nortel VPN to Cisco AnyConnect as the remote connection solution.
I have downloaded and installed the tarball (anyconnect-predeploy-linux-3.1.00495-k9.tar.gz) with no problems.
The anyconnect gui launches, and I can connect to the corporate network with no problems.
However; the connection consistently fails after ~2 minutes. To re-establish a connection I need to force a disconnect, then repeat the connection sequence
I am running ubuntu 12.04 (64bit) on a Toshiba Portege laptop. Firewall is disabled when I am making the connection
Any ideas on what is happening to kill my connection after the initial success?
thanks - jmr