cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Who Me Too'd this topic

Cisco 2960 PoE failing: "PD Removed" error

cisbsdnbhd
Level 1
Level 1

Hai,

I'm facing a problem where certain port on my swtich keep grant and remove poe.

Nov 12 07:02:43.639: %ILPOWER-5-POWER_GRANTED: Interface Gi1/0/18: Power granted

Nov 12 07:02:44.399: %ILPOWER-5-IEEE_DISCONNECT: Interface Gi1/0/18: PD removed

Nov 12 07:02:53.952: %ILPOWER-7-DETECT: Interface Gi1/0/18: Power Device detected: Cisco PD

Nov 12 07:02:55.268: %ILPOWER-5-IEEE_DISCONNECT: Interface Gi1/0/18: PD removed

Nov 12 07:03:04.805: %ILPOWER-7-DETECT: Interface Gi1/0/18: Power Device detected: Cisco PD

Nov 12 07:03:05.398: %ILPOWER-5-IEEE_DISCONNECT: Interface Gi1/0/18: PD removed

Nov 12 07:03:15.680: %ILPOWER-7-DETECT: Interface Gi1/0/18: Power Device detected: Cisco PD

Nov 12 07:03:16.440: %ILPOWER-5-IEEE_DISCONNECT: Interface Gi1/0/18: PD removed

Nov 12 07:03:26.024: %ILPOWER-7-DETECT: Interface Gi1/0/18: Power Device detected: Cisco PD

Is it a hardware problem?

I've tried to reboot and reconfigure. Apparently none of them are working.

Is there any solution for this matter asside from RMA request? I just want to make sure whether is it a hardware or miss configuration problem.

The software version is

Cisco IOS Software, C2960S Software (C2960S-UNIVERSALK9-M), Version 12.2(55)SE3, RELEASE SOFTWARE (fc1)

Here are the port configuration

interface GigabitEthernet1/0/18

switchport access vlan 2

switchport mode access

switchport voice vlan 14

switchport port-security maximum 2

switchport port-security

srr-queue bandwidth share 1 30 35 5

queue-set 2

priority-queue out

udld port aggressive

mls qos trust device cisco-phone

mls qos trust cos

auto qos voip cisco-phone

storm-control broadcast level 15.00

spanning-tree portfast

spanning-tree bpduguard enable

spanning-tree guard root

service-policy input AUTOQOS-SRND4-CISCOPHONE-POLICY

ip verify source

end

Thanks

Who Me Too'd this topic