11-13-2012 01:11 AM - edited 03-07-2019 10:00 AM
Hello all,
I met a strange problem after enabling flowcontrol in 2960s.
my enviroment,
- 2 cisco 2960s 24ts-l have been created a stack
- IOS is 12.2(58)se2
- all ports have been enabled flowcontrol receive dersied
via show flowcontrol, I can see each Gigabyte Port have been enabled "flowcontrol receive desired" but, when I do the following tests
- connect equallogic ps4000xv to the port 21, I found the status of port is "input flow-control is off"
- connect one server with Broadcom Gigabyte Network adapter, which has been enable TX ON RX ON, or Auto, the status of the port is still "input flow-control is off"
I guess, the port status should be ""input flow-control is on". Test them with another port, I got the same result. why?
I attached the config file and the port status file.
Any help will be appreciated.
Alex
Solved! Go to Solution.