11-29-2012 08:01 AM - edited 02-21-2020 06:31 PM
I am setting up AnyConnect on a ASA that has two ISP connected on different public interfaces. I am using a 5515X with the 8.6 code. At the current time I am using a self sign certificate. I can get AnyConnect to work on one of the public interfaces but when I try to enable Anyconnect on the secondary interface, I cannot establish an anyconnect session on either of the public interfaces.
I need to set it up so that I can connect from either ISP. There will be a Primary ISP but in the event there is a routing problem with the ISP, I need for users to connect via either ISP. Havent been able to find any info that says this is or isnt possible.
I was trying to use the same self signed cert for both public interfaces. I am going to try to use a separate self signed cert and see if that makes any difference but wanted to see if anyone else had done this.
Thanks,
Ron