Hi ,
We are deploying two Cisco 5585 in transparent mode and multiple contexts. they are runnign Active-Active failover.
There are a lot of VLANs need to be added in the contexts, we are trying to use least contexts to fulfill.
ASA supports 8 bridge groups for each contexts, and maximum 4 interfaces for each bridge group.
We have assigned four interfaces in different VLANs , set two of them as a pair with one IP subnet and the other two interfaces are in another IP subnet.
For example :
Bridge group 1:
inside1 and outside1 -------> 192.168.1.0/24
inside2 and outside2 -------> 192.168.2.0/24
However, we can only make one subnet(VLAN pairs ) work when the BVI is set to that IP subnet.
If the BVI set to 192.168.1.0/24, the inside1 and outside1, the other pair not work. If the BVI set 192.168.2.0/24, then only inside2 and outside2 work.
Since the BVI can only be assigned to either of the subnet, Is it possible to make both vlan pairs work ?
Or we only can have one subnet in one bridge group ?
Thanks
Veon
