07-03-2013 12:55 PM - edited 03-07-2019 02:13 PM
I had read somewhere that the commit command under switch profile configures the commands that are in the buffer and saves the configuration. I see the commands under 'show run switch-profile' and 'show run', but I don't see the commands configured under 'show start' and 'show start switch-profile'. This is the same on both 5K switches. If I do a 'copy run start' on one switch, the config does show up under the startup config on that switch only. Do you need to copy the config after comitting a switch-profile and if so, do you have to do it on both switches?
Thank you,
Mark