cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Who Me Too'd this topic

Rommon not responding to keystrokes

glenn-mchenry
Level 1
Level 1

I have a Cisco 2960S-48FPD that someone was trying to do an upgrade, loaded c2960-lanbasek9-mz.150-2.SE2.bin instead of c2960-universalk9-mz.150-2.SE2.bin.  To try and fix it they deleted both but before they could put the proper ios on, another person dropped power.  Now the switch will boot into rommon, HOWEVER it won't respond to any keystrokes.  It's stuck at "..... flash_init boot " and the switch: prompt.  I have tried using both putty and SecureCRT, the settings are correct, the usb-serial works on another c2960S.  I can read the output when it goes into rommon so it's not a baud rate issue.  Any help to turn this brick back into a functioning switch is greatly appreciated.

Thanks!

Glenn                  

Who Me Too'd this topic