08-02-2013 04:00 AM - edited 03-01-2019 07:22 AM
If entity traps are enabled, will the failure of a PSU in a FEX (with 2 PSU's) result in a trap being sent or are the entity traps only for the 5000 rather than the 2000.
Reason for asking:I have a number of failed PSU's in FEX's which might have been a failed since power on and therefore have never transitioned from working to failing to send a trap. The FEX itself is constantly complaining of voltage issues
08/02/2013 04:52:41.572800: Err:over volt fault occured for ps:1
08/02/2013 04:52:41.572839: Err:stat=2048
08/02/2013 04:52:41.572853: Err:over-output-current fault occured ps:1
08/02/2013 04:53:14.936602: Err:over volt fault occured for ps:1
08/02/2013 04:53:14.936645: Err:stat=2048
08/02/2013 04:53:14.936658: Err:over-output-current fault occured ps:1
08/02/2013 04:52:41.572800: Err:over volt fault occured for ps:1
08/02/2013 04:52:41.572839: Err:stat=2048
08/02/2013 04:52:41.572853: Err:over-output-current fault occured ps:1
08/02/2013 04:53:14.936602: Err:over volt fault occured for ps:1
08/02/2013 04:53:14.936645: Err:stat=2048
08/02/2013 04:53:14.936658: Err:over-output-current fault occured ps:1
08/02/2013 04:53:30.46732: satctrl_alive_hdlr: alive_count is 23001700
Power Supply Fex 103:
---------------------------------------------------------------------------
Voltage: 12 Volts
-----------------------------------------------------
PS Model Power Power Status
(Watts) (Amp)
-----------------------------------------------------
1 -- -- -- fail/shutdown
2 N2200-PAC-400W 396.00 33.00 ok
Thanks Andy Metcalf