I apologize for the stupid question but I am so insanely rusty with ASA firewalls it's completely ridiculous! I have about 24 remote users connecting to our ASA 5510. These users pull an IP address from a DHCP scope setup on the firewall in the 172.16.16.100-172.16.16.250 range. I need to be able to ping these users machines over their VPN tunnels. I was under the impression that adding "same-security-traffic permit intra-interface" would allow this but it doesn't. Do I need an ACL for this? What would it look like? I've attached my running config. Maybe I should add that this firewalls only purpose is for these VPN users.
Thanks for the help in advance! You'll save my life!!
