11-25-2013 05:20 AM - edited 03-04-2019 09:40 PM
I want to implement port security on one of the fastethernet ports on a Cisco 887VAG but the switchport port-security command is not available.
All i want is to bind a mac address to fastethernet 0, the only command that looks relevant is the 'switchport protected'.
Whats the best way to do this?
interface FastEthernet0
description Printer
no ip address
end
router-new(config-if)#switchport ?
access Set access mode characteristics of the interface
mode Set trunking mode of the interface
priority Set 802.1p priorities
protected Configure an interface to be a protected port
trunk Set trunking characteristics of the interface
voice Voice appliance attributes