Hi
When I use graph it to monitor the utilization of one of our WAN interfaces I get the following error:
No Such Instance - The specified instance is not available
When I snmpwalk both ifHCInOctets and ifHighSpeed I get the correct values - this is a gigbait interface. For some reason HUM is giving this error when I try to do a graph with our bandwidth usage (Graph IT) - I know I may use Cacti but I would like to use LMS to do this job.
[U-SRVLMS/root-ade logs]# snmpwalk -v 2c -m ALL -c xxxxxxx 172.31.34.254 ifhcinoctets
IF-MIB::ifHCInOctets.1 = Counter64: 0
IF-MIB::ifHCInOctets.551 = Counter64: 14381089
IF-MIB::ifHCInOctets.559 = Counter64: 5813547957
IF-MIB::ifHCInOctets.10101 = Counter64: 0
IF-MIB::ifHCInOctets.10102 = Counter64: 0
IF-MIB::ifHCInOctets.10103 = Counter64: 0
IF-MIB::ifHCInOctets.10104 = Counter64: 0
IF-MIB::ifHCInOctets.10105 = Counter64: 0
IF-MIB::ifHCInOctets.10106 = Counter64: 0
IF-MIB::ifHCInOctets.10107 = Counter64: 0
IF-MIB::ifHCInOctets.10108 = Counter64: 0
IF-MIB::ifHCInOctets.10109 = Counter64: 0
IF-MIB::ifHCInOctets.10110 = Counter64: 7836856738
[U-SRVLMS/root-ade logs]# snmpwalk -v 2c -m ALL -c xxxxxxx 172.31.34.254 ifhighspeed
IF-MIB::ifHighSpeed.1 = Gauge32: 1000
IF-MIB::ifHighSpeed.551 = Gauge32: 1000
IF-MIB::ifHighSpeed.559 = Gauge32: 1000
IF-MIB::ifHighSpeed.10101 = Gauge32: 10
IF-MIB::ifHighSpeed.10102 = Gauge32: 10
IF-MIB::ifHighSpeed.10103 = Gauge32: 10
IF-MIB::ifHighSpeed.10104 = Gauge32: 10
IF-MIB::ifHighSpeed.10105 = Gauge32: 10
IF-MIB::ifHighSpeed.10106 = Gauge32: 10
IF-MIB::ifHighSpeed.10107 = Gauge32: 10
IF-MIB::ifHighSpeed.10108 = Gauge32: 10
IF-MIB::ifHighSpeed.10109 = Gauge32: 10
IF-MIB::ifHighSpeed.10110 = Gauge32: 1000
IF-MIB::ifHighSpeed.10501 = Gauge32: 10000
This a 3560C switch running this image:
Is there something I am missing?
Switch Ports Model SW Version SW Image
------ ----- ----- ---------- ----------
* 1 10 WS-C3560CG-8TC-S 15.0(2)SE3 C3560c405ex-UNIVERSALK9-M
Best regards
Isaac
