12-04-2013 02:26 PM - edited 03-07-2019 04:55 PM
Good afternoon - I am turning up a circuit (4 t1's actually, bonding them together) and I am a little unsure how to do this. This will not be a point-to-point circuit, but 4 t1's bundled into a multilink interface. This is a Cisco 2951 ((C2951-UNIVERSALK9-M), Version 15.1(3)T1) with 3 open wic slots. I have 1 VWIC2-2MFT-T1/E1 card and 2 VWIC2-1MFT-T1/E1 cards.
We are controlling BGP, and this is on an MPLS network.
I think I have it configured correctly, but I was unsure if I put the total bandwith on the multilink interface or if I it on each serial interface respectfully.
I will have it programmed as such:
card type t1 0 1
card type t1 0 2
card type t1 0 3
Controller t1 0/1/0
framing esf
linecode b8zs
clock source line
channel-group 0 timeslots 1-24
Controller t1 0/1/1
framing esf
linecode b8zs
clock source line
channel-group 0 timeslots 1-24
Controller t1 0/2/0
framing esf
linecode b8zs
clock source line
channel-group 0 timeslots 1-24
Controller t1 0/3/0
framing esf
linecode b8zs
clock source line
channel-group 0 timeslots 1-24
-----------------------------------------------------------------
interface serial 0/1/0:0
no ip address
encapsulation ppp
multilink
ppp multilink group 1
interface serial 0/1/1:0
no ip address
encapsulation ppp
multilink
ppp multilink group 1
interface serial 0/2/0:0
no ip address
encapsulation ppp
multilink
ppp multilink group 1
interface serial 0/3/0:0
no ip address
encapsulation ppp
multilink
ppp multilink group 1
--------------------------------------------------------------------
description 6MB mpls circuit
bandwidth 6176
ip address 1.2.3.4 255.255.255.252
ip route-cache flow
no cdp enable
ppp multilink
ppp multilink group 1
ppp multilink fragment disable
!
Router BGP 65002
bgp log-neighbor-changes
network 192.168.1.0
network 192.168.2.0
redistribute connected
redistribute static
neighbor 1.2.3.3 remote-as 123
neighbor 1.2.3.3 soft-reconfiguration inbound
ip route 0.0.0.0 0.0.0.0 1.2.3.3
Any input is greatly appreciated; I'm pretty sure I have this set up correctly
Thanks!
Joel
Solved! Go to Solution.