06-02-2014 05:58 AM - edited 03-18-2019 03:02 AM
Hi-
I understand in TC7 there was a change made to how the codec reacts when a presentation source is removed.
From the release notes:
Presentation will stop when presentation source is disconnected
If a presentation source is disconnected or goes into standby (e.g. a PC), the presentation will
automatically be ended after 10 seconds. If the source is connected or comes out of standby within 10
seconds, the presentation will automatically be resumed.
This works against us in our workflow (mainly TCS recordings). Is there a setting that preserves the old TC6 behavior? Or perhaps a way to extend the 10 seconds to 60 or 120?
Thanks
Dan