09-07-2014 12:58 PM
Hello,
I have a basic configuration on this SG300-52 :
From the SG-300 :
There is no inter-VLAN routing, but I cannot find how to enable it...
The complete configuration is the following :
SG300-52#show run
config-file-header
SG300-52
v1.4.0.88 / R800_NIK_1_4_194_194
CLI v1.0
set system mode router
file SSD indicator encrypted
@
ssd-control-start
ssd config
ssd file passphrase control unrestricted
no ssd file integrity control
ssd-control-end cb0a3fdb1f3a1af4e4430033719968c0
!
vlan database
vlan 99
exit
voice vlan oui-table add 0001e3 Siemens_AG_phone________
voice vlan oui-table add 00036b Cisco_phone_____________
voice vlan oui-table add 00096e Avaya___________________
voice vlan oui-table add 000fe2 H3C_Aolynk______________
voice vlan oui-table add 0060b9 Philips_and_NEC_AG_phone
voice vlan oui-table add 00d01e Pingtel_phone___________
voice vlan oui-table add 00e075 Polycom/Veritel_phone___
voice vlan oui-table add 00e0bb 3Com_phone______________
bonjour interface range vlan 1
hostname SG300-52
username cisco password encrypted c464af817287343305cbd6493c593885695df531 privilege 15
ip ssh server
snmp-server server
ip telnet server
!
interface vlan 1
ip address 10.0.0.1 255.255.255.0
no ip address dhcp
!
interface vlan 99
name WAN
ip address 192.168.0.2 255.255.255.248
!
interface gigabitethernet49
switchport mode general
switchport general allowed vlan add 99 untagged
switchport general pvid 99
!
exit
ip default-gateway 192.168.0.1
Do you have any idea about the issue ?
Thanks in advance for your help.
Solved! Go to Solution.