10-10-2014 01:52 PM - edited 03-11-2019 09:54 PM
I have 2 ASA 5520 setup in routed failover cluster.
The primary active unit has all the right information.
The secondary standby unit seems to have the right routing info but when i log in there and attempt to ping something not on a local connected network it fails.
sh ro
show me the same route table as the primary active unit.
This used to work. it seemed to stop working around the time i did some fail over testing. Now I can't seem to ping it from remote locations, which is interesting as I can ssh to it !