10-17-2014 01:42 PM - edited 03-07-2019 09:10 PM
We have a 4507R+E with dual Sup7-E's running IOS 15.1(2) SG4. The license level is LANBase. I am creating the initial configurations for the switch but cannot change the uplink state of the SFP ports on the supervisors. I tried to run the command HW-MODULE UPLINK SELECT but it is not present. These are the only option available under HW-MODULE.
switch(config)#hw-module ?
module Specify a linecard slot for the hw-module command
slot Specify a linecard slot for the hw-module command
system Specify the system parameter
Is this a license restriction?
Solved! Go to Solution.