Hello,
We have a loaner ACI simulator UCSC-220 box which we have installed the simulator software on, however we are having trouble getting it fully configured and usable. Each of the 3 APICs have been configured with IP addresses, following the installation guide instructions. We also have cabled the rear-panel with ports 1, 2, 3, 7, and 8 connected to an upstream switch that connects to our corporate network. Using the APIC1 UI I added an external routed network connection, using a static route to send packets out the leaf1-1-40 interface to our upstream gateway as next hope, if the packets are destined for our external (i.e. corporate) subnet. Note that port 40 on leaf1 maps to port 2 on the rear-panel I believe. The cable on port 2 shows a link-status light of green.
After doing that, I expected to be able to SSH into the leaf1 switch and ping out to a machine on our corporate subnet. However when I try to do so I get a "Network Unreachable" error.
Any suggestions as to what we might be doing wrong here?
Thanks in advance,
Steve
