04-06-2015 08:24 AM
Pre-Sales support advised that the 702i will operate as a stand alone AP in autonomous mode. When I purchased the device it came with instruction for setting up the device but only in a controller based configuration. I see the mode button on the device but the documentation says it will do a factory reset for only Autonomous mode AP's.
I called for support but the support rep said the device does not qualify for technical support, only hardware support or replacement. I find it hard to believe Cisco is selling a product but not providing documentation on how to fully configure the device and then saying over the phone they will not help with a configuration questions.
How do I get the device into Autonomous mode?