Odd problem when configuring SLA on an ASA, i keep getting route lookup failure when trying to ping an remote host across an IPSEC tunnel. I've tried the below utilizing both the inside and outside interfaces but both fail. The ping from the ASA is successful which is confusing. I've masked the IP's.
sla monitor 1
type echo protocol ipIcmpEcho x.x.x.x interface outside
frequency 5
sla monitor schedule 1 life forever start-time now
sla monitor 2
type echo protocol ipIcmpEcho x.x.x.x interface inside
frequency 5
sla monitor schedule 2 life forever start-time now
%ASA-6-110003: Routing failed to locate next hop for icmp from NP Identity Ifc:x.x.x.x/0(inside interface of ASA) to inside:x.x.x.x/0(remote system i'm trying to ping)
Successful ping:
FW01# ping inside x.x.x.x
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to x.x.x.x, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 40/44/50 ms
Thoughts or suggestions would be appreciated.
